Home     Products     Links & Information     About Us     Contact Us     Incom

Top Laddermate™ (#LM200)

Installation on Pole

GO TO INSTALLATION ON STRAND

Properly position ladder as shown. If the ground is uneven, a ladder leveling wedge should be used. Be sure to leave at least 12" of clearance between the top of the ladder and any obstruction. Properly install bottom Laddermate (#LM100) according to Laddermate Procedures For Use.

Securing the top of the ladder to the pole with Top Laddermate:

1. After securing the bottom of the ladder with the bottom Laddermate (#LM100), ascend the ladder to the top and secure yourself with your body belt.

2. Attach the Top Laddermate to the left side rail (right side if left handed) below the top rung in the same manner as the bottom Laddermate.

3. Wrap the opposite end of the strap away from you, around the backside of the pole and attach to the opposite rail below the top rung.

4. Reach behind the pole, grasp the free end of the strap and pull to snug. Be sure to pull away from your body and the pole (your body should lean “into” the pole).

Attach to left rail.

Around back of pole, attach to right rail.

Pull free end of strap to snug.

Removal:

With your body belt still secured, acuate the release on the cam buckle. This will allow sufficient slack to be obtained to release the buckles and remove the Top Laddermate.

Procedures Literature (Adobe PDF)

GO TO INSTALLATION ON STRAND